
Your Ultimate Gateway to Skype
TM
VoSKY Exchange Pro VIT1/E1 User Manual
. 11 .
Your Ultimate Gateway to Skype
TM
VoSKY Exchange Pro VIT1/E1 User Manual
Parameters E1 settings T1 settings
Tone zone US US
Timing (Clock source) 0 0
LBO 0 0
Framing ccs esf
Coding hdb3 b8zs
CRC4 enabled Enabled Disabled
B-channels 1-15,17-31 1-23
D-channels 16 24
Switchtype euroisdn national
Signalling (Termination side)
pri_net(only
supports pri_
net)
pri_net(only
supports pri_net)
Group 1 1
Language EN EN
Receive Wink Timing 300 300
2.3
Connecting Exchange Pro VIT1/E1 to the PBX
After completing the above steps, perform the following procedure to connect
Exchange Pro VIT1/E1 to a PBX:
Warning: Before you operating the following steps, make sure that
the power to the PC is turned off and that the power cord is
unplugged.
1. Connecting the E1/T1 port on Exchange Pro VIT1/E1 backplate to the
E1/T1 port on the PBX using the provided RJ-48 cable as shown below:
2. If the provided cable is not applicable to your PBX, please refer to
Appendix D to make an appropriate interface or ask for your reseller.
Comentarios a estos manuales