VoSKY Exchange Pro E1 Manual de usuario Pagina 102

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 116
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 101
Your Ultimate Gateway to Skype
TM
VoSKY Exchange Pro VIT1/E1 User Manual
. D-3 .
Your Ultimate Gateway to Skype
TM
VoSKY Exchange Pro VIT1/E1 User Manual
Cut the outer sleeve of the RJ-48 cable about 1.5” to 2” from the cross b.
over end, then punch the cut end of the DB-15 cable and RJ-48 cable
into the punch block according to the following wire numbering.
RJ-48 Connector to DB-15 Connector (Straight)
RJ48 Pin
(on VIT1/E1)
DB-15 Pin
(on your PBX)
Signal
1 11 RX- <-->RX-
2 3 RX+ <-->RX+
4 9 TX- <-->TX-
5 1 TX+ <-->TX+
4. If the E1/T1 port on your PBX has a DB-15 connector with cross-over
connection, please make a RJ-48 to DB-25 cable according to the
following steps.
Cut the DB-15 cable from the end, and separate pins 1, 3, 9 and 11 a.
according to the sketch map above.
Cut the outer sleeve of the RJ-48 cable about 1.5” to 2” from the cross b.
over end, then punch the cut end of DB-15 cable and RJ-48 cable into
the punch block according to the following wire numbering.
RJ-48 Connector to DB-15 Connector (Cross-Overt)
RJ48 Pin
(on VIT1/E1)
DB-15 Pin
(on your PBX)
Signal
1 9 RX- <-->TX-
2 1 RX+ <-->TX+
4 11 TX- <-->RX-
5 3 TX+ <-->RX+
Note: Any pin not referenced is not connected.
Vista de pagina 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 115 116

Comentarios a estos manuales

Sin comentarios